PDA

View Full Version : Tunze


Pages : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 [67] 68 69 70

  1. Tunze 9004
  2. Tunze 9410 hydrofoamer on h&S a-150 f2001
  3. Osmolator Issue
  4. Tunze 9012
  5. Tunze osmolator issues
  6. Osmolator Nano issues
  7. Tunze 9004 - C130 Fit
  8. Tunze 9012 unit - questions about bubbles...
  9. Osmolator pump is not turning on when it should.
  10. Tunze Care Magnet
  11. Restricting flow on 1073.040
  12. Help adjusting Tunze ATO 3152 -- too much water!
  13. Tunze 6105
  14. 6055 Propeller won't spin anymore
  15. Tunze 9011 performance?
  16. Frag plug
  17. Issue with 9410
  18. Order problems
  19. Connecting two 6040 together, got MIDI cable
  20. Availability of 7090.300 y-cable and 7097.050 moonlight
  21. 9004 silencer replacement
  22. 6105 replacement impellar - question for Tunze
  23. tunze osmolator
  24. Osmolator stopped pumping to height
  25. 3152 ATO, upgrade??
  26. Which pumps?
  27. tunze osmolator
  28. Tunze 7096 stops working after a few hours
  29. 6055 problem
  30. Stream 6205 stopped working
  31. Osmolator sensor
  32. osmolator malfunction
  33. Tunze 9001 and loose magnets
  34. Tunze 5017 no water pumping
  35. 6125 impeller
  36. Tunze 9001 skimmer air hose came off?
  37. Osmolator 3152 Nano ATO quit working
  38. TDS Manual
  39. TUNZE osmolator ( ATO ) problem !
  40. Loose and bent 6095 impeller post...
  41. Biology Department Tunze
  42. Jumper
  43. 6040 in a 5.5g
  44. Tunze Osmolator
  45. Which Turbelles for a 180 gallon?
  46. Calcium reactor
  47. Noisy Tunze 9012
  48. Tunze ATO 3155
  49. Which Turbelles for a 92 gallon?
  50. My Tunze 6055 didn't work anymore.
  51. Tunze 9010 Skimmer
  52. Replacement Tunze ATO float switch?
  53. Tunze 9430.040
  54. Tunze Osmolator 3155
  55. 6040 and 7095 Together
  56. osmolator problem
  57. 6155 power supply dead?
  58. 6105 not working
  59. Tunze 9010 Skimmer drive unit
  60. Tunze osmolator 5017
  61. Urgent Battery Backup question
  62. 6025 Broken Bracket.
  63. Tunze Osmolator 5017 - Not Working
  64. 9415 DOC skimmer
  65. Safety connector
  66. Tunze 6100 not working
  67. Tunze 9004 not skimming as it was...any advice welcome
  68. Two 6040s Connected in Wave Mode
  69. 6020 just stopped running
  70. Tunze 9001 micro bubbles
  71. 5017 Too high & Too low at same time
  72. 3155 Pump making noise
  73. 3155 help!!
  74. Controller 7095 or 7096 ?
  75. 3155 help
  76. Tunze Osmolator nano 3152 - damaged equipment-BNIB?
  77. Osmolator 3155
  78. Tunze magnet malfunctioning with 3155?
  79. 7097.050 Moon Light Flashing Off and On
  80. 3152 ato pump issues loosing suction
  81. Issue with 3155
  82. Address for service
  83. Safety Connector Need for UPS BackUp?
  84. tunze ato issues
  85. Osmolator issue.
  86. ATO Sensor Wires
  87. Wavebox on rimless tank OK?
  88. Tunze 9001 help
  89. Safety harness not working
  90. 7096 Controller Software and drivers for Mac
  91. Snail problems with Nano Osmolator 3152
  92. Tunze Pump Silence 1073.050 busted impeller.
  93. Osmolator 3155 issue
  94. pumps compatible with 7096?
  95. Tunze osmolator 3155
  96. Tunze 6205
  97. Tunze Comline Streamfilter 3163
  98. 6040 acting strange.
  99. Skimmer advice
  100. Tunze Calcium Dispenser 5074
  101. Issue with new 3152 Osmolator
  102. Tunze osmolator
  103. extra cables?
  104. 6055 not powering 7091
  105. Missing Parts From Tunze 1073.11
  106. 6055 not working
  107. 6105 Wide Flow
  108. Tunze "strong" magnet algae scrapper
  109. Resonance waves, the Osmolator 3155 sensor and the foodtimer.
  110. Tunze 9012 skimmer
  111. Almost new 3152 not working
  112. Problem with Osmolator
  113. Tunze 6105 stops working after a few mins
  114. Why are the impellers blue?
  115. How frequently can I start/stop 6045/6025 ?
  116. Magnet is rusting?
  117. Care magnet blade rusting?
  118. 2 6105's and 7096 all went out
  119. Tunze osmolator nano
  120. I have a 6055 not controllable
  121. Tunze nano osmolator 3152.
  122. Help me select the right Turbelle
  123. tunze ATO odd issues
  124. Tunze 6105 replacement impeller
  125. 3155 Amps?
  126. tunze magnet cleaner
  127. Tunze 9001 no longer foaming after sump install
  128. Problems with 9410
  129. Modifying 6105 cover
  130. Nano Wavebox 6206 vs. Comline Wavebox 6208?
  131. Tunze Osmolator Pump
  132. Osmolator false alarm
  133. Nano ATO issue
  134. Tunze 9001
  135. Is this how loud the Tunze 9004 is supposed to be during break in?
  136. Best Tunze placement for 6105's in a 120
  137. 6215 with very loud click/unseated impeller
  138. 3155 issues
  139. 6155 power supply died
  140. Tunze 9004 in a sump
  141. tunze ato will not turn on
  142. 6255 Stopped working
  143. Tunze 6105 magnet not capable?
  144. New 6040 not working correctly
  145. Replacement tubing for Tunze osmolator
  146. 6101 not running
  147. Tunze auto top off pump
  148. Where can I get a 7097.050 (I think that's the one)
  149. 9015 question
  150. 9420 impleller
  151. Tunze USA is terriffic! Thank you Roger for the great support!
  152. Tunze Osmolator 3155 Problem. Sensor Problem.
  153. 9004 Airline Tubing size?
  154. Tunze 3152 Not Turning One
  155. Using the 6215.200 pump seperate from the wavebox
  156. Pre 2009 DOC 9002 skimmer impeller
  157. 6095
  158. tunze 9140
  159. 6040 Anti Sync Mode
  160. Tunze Osmolator Nano (3152) won't shut off
  161. 6155 bracket
  162. 9410 DOC Skimmer very light colored skimmate
  163. Which skimmer ?
  164. 6125 Won't restart after power is lost
  165. Rusted Magnet on Tunze Nanostream
  166. 9012 pumps
  167. Osmolator sensor failure
  168. Tunze circulation in Cube
  169. 7096 Foodtimer will not engage
  170. Failed 6105
  171. 6215 wavebox placement
  172. 6095 Turbelle not working
  173. Tunze 9004 Tuning?
  174. 6125 Won't stay together
  175. 6101 for 90 gal island
  176. Very impressed with the 9415 skimmer
  177. Replacement Parts
  178. Max Min Flow 6095
  179. Nano 3152 pump failure
  180. wide flow kit for 6105
  181. Tunze 3155 pump won't stop pumping
  182. Tunze Nano Osmolator 3152
  183. 6105 burned up
  184. Safety Connector Not Working
  185. 9410 Skimmer
  186. need a part for 6105
  187. New Tunze 6055 with Controller?
  188. using apex to control tunze 8850
  189. Tunze 9012 impeller/foamer problem
  190. Tunze 6095 problem
  191. New nano 3152 doesn't work?
  192. Tunze 6020
  193. Silence 1073.05 pump instructions?
  194. Sell me on the 9415
  195. Controlling just one 6040 nano with apex
  196. new 7096 controller missing a part
  197. 5107 Too Low light
  198. Nanostream holder starting to rust in tank
  199. Is the Tunze Turbelle Nanostream 6040 good for my 20 gallon?
  200. Tunze 6200.50
  201. Tunze 6040 or 6095
  202. Blue 6045
  203. 9004 skimmer and osmolator
  204. Anyone still run tunze 6000 or 6100's?
  205. SPS Cube
  206. Osmolator 5017 not functioning
  207. 7090 controller
  208. Tunze Wavebox and 6040 nanostream
  209. Tunze 9001 sliding down into tank
  210. Battery backup / safety connector
  211. Tunze wavebox question. Is it good for my tank?
  212. Tunze Nano osmolator pump gets stuck
  213. Tunze Nanl DOC 9002 replacement pump
  214. Tunze 3152 Osmolator pump issue
  215. Tunze 7074/2 - CO2/pH controller set
  216. Tunze 9001 - foaming out the back
  217. Tunze Osmolator 5017 Malfuntioning
  218. 6040 or 6055/95
  219. 9002 magnet move?
  220. 6025.501 magnet extension
  221. 3155 osmolator pump black hose diameter
  222. Tunze Photo-Electric Cell 7097.050
  223. Tuning in a used 9004
  224. New Streams with Controller
  225. Magnet Issue- Comments appreciated
  226. Tunze Osmolator Universal 3155 Sensor Issue
  227. New TUNZEŽ 1073.060 recirculation pump
  228. Comline Filter 3162.500 magnet extension
  229. Float switch/magnet kit?
  230. New Nano 800.04_A pump not working!
  231. Broken 6045 - question
  232. osmolator wont prime
  233. Which Wavebox to use?
  234. I broke
  235. tunze 9012 help, no foam after unplugging.
  236. 7096 controller issues
  237. Return pump for new set up
  238. Osmolator 3155 failure
  239. wavebox 6208
  240. Tunze calcium reactor
  241. Tunze 6020 loud
  242. 6055 power supply issue
  243. Skimmer recommendation
  244. Impellar
  245. Tunze DC skimmers
  246. 6000's power supply
  247. Safety connector not working when power goes out
  248. 9004 skimmer required water depth
  249. 6040 Question
  250. Tunze Osmolator failure