triggerfish2
05/13/2007, 02:10 AM
need some advice on the following.
been using aquamedic NR1000. bought a pinpoint orp controller however couldnt make head/tail on the range/centre values settings.
from the NR1000 manual, recommended settings for the denitrator should be -50 to -300 mV.
however, the lowest range for the controller is only -100 mV.
anyone been using he pinpoint controller too? kindly advise. thanks
been using aquamedic NR1000. bought a pinpoint orp controller however couldnt make head/tail on the range/centre values settings.
from the NR1000 manual, recommended settings for the denitrator should be -50 to -300 mV.
however, the lowest range for the controller is only -100 mV.
anyone been using he pinpoint controller too? kindly advise. thanks