tunze problem

[WWC]

hi

got a problem... we moved the 92 gal and when we set it back up one of the 2 tunzes stopped working. the blades of the impellar seem to be vibrating back and forth instead of spinning in a full rotation. any ideas?

(p.s. we did store all the magnetic drive pumps together during the move.. maybe they reversed polarity???)

[rvitko]

See the top thread on cleaning, I suspect salt and debris crusted the parts inside together.

[WWC]

I finally found the problem. It looks like the circuit board is burned up! Maybe it got a little water in there, during the move. Can I get, just the board, for a 7240.27?

Thank you.

[rvitko]

We don't sell the board alone as it is difficult to install properly. The housing is critical as a heat sink. I will send a PM.