PDA

View Full Version : Questions for an owner of a Tunze Nano DOC 9002 skimmer


Reefmack
06/22/2007, 09:15 AM
I'm trying to determine if the Nano DOC 9002 would fit in the rear filtration compartment of my 34 gallon Red Sea Max tank:

1) I need to know the width (diameter) of the skimmer cup?

2) What is the height of the skimmer cup - not including the tube
underneath - just the height of the exposed part that would be sitting on top of the main unit after sliding it in place.

3) I can't tell from the online manual that I looked at - how does the unit actually attach to the hanging rack does it slide onto the rack or ?

4) Is the vertical position of the skimmer on the hanging rack
adjustable up & down, to account for the actual water level?

Thanks

Tetsugen
09/28/2007, 04:04 AM
Any updates to this? Apologies for bumping an old thread.

victor_c3
09/28/2007, 04:24 AM
try posting this on the "Tunze" forum under the Vendor Forum section of reefcentral.

The few times I had questions on tunze products, I usually got an answer within a few hours from a service rep.

Chris2500DK
09/29/2007, 12:43 AM
The cup is 95 mm (3 3/4 inches) in diameter at the top and just about 100 mm (4 in) high above the body of the skimmer.

I can't tell you anything about the bracket mount as my 9002 came as part of the reefpack so I have the magnet mount.