6200 not working

[Rattleramm]

my pump is not working and when u connect it to the7095 the lights blink like crazy all over. this is do to a overflow and it got slightly damp. my question is can this be repaired or am i out. thanks Ron

[Manaz]

If you got salt water in the electronics, my guess is you're probably not in a good position.

You may find that rinsing well with clean, fresh water (RO/DI would be ideal) and then letting it dry out completely MAY help if you find you're out of options - it's something I'd want to try sooner rather than later though, as salt is corrosive and can easily damage electronics if left for too long.

[rvitko]

As Manaz said. What got wet the driver or the controller or both?

[Rattleramm]

i think just the driver. it makes a low pitch continous noise when plugged in, and if i connect it to the controller the controller acts eratically.

[rvitko]

I would open the driver and check, very minor damage to a connection or damage from freshwater may be remedied by washing the unit in distilled or RO/DI water and letting it dry thoroughly. For good measure I would wash it with 90% or higher isopropyl alcohol as well.

Otherwise I could offer you a new driver at a discount.