PDA

View Full Version : Problems with Osmolator


Saltfun2003
07/28/2007, 01:15 PM
My problem started with saying pump is on but not pumping water. Unplugged unit for a few days so i could find my meter to mesure if it was getting voltage to the pump. Now when i plug the unit back in the water full alarm sounds water lvl to high led is on and the low lvl led is flashing.

rvitko
07/30/2007, 09:11 AM
The two most common causes of this are magnetic interference from ballasts and large motors or magnet holders/cleaners. Or, the controller got wet. If you have ruled out both of these, send the unit to me and I will have a look, include a receipt if you have one.

Tunze USA
305 Victor St
Austin, TX 78753