PDA

View Full Version : 6025 stoped working


gosaints
08/04/2007, 09:48 AM
i turned off the pump when i turned the pump back on their was some rattling and it wouldn't stop so i turned it off then on again the noise stopped and i thaught no big deal. the next morning i noticed it wasn't working at all. i took it apart and found a little silver washer loose inside. does this go on the plastic under the magnet? could i just glue it back in place? also could the moter be damaged by running without the prop spinning?

Aquadepot
08/04/2007, 09:53 AM
gosaints,

Yes the washer goes at the bottom of the stainless steel shaft and should not be glued, also check the shaft is firm in the motor block. The motor block should not be damaged by this.

Regards
Graeme

gosaints
08/04/2007, 10:07 AM
i just took apart my other 6025 and took a look . the shaft on the other one is broken off inside the magnet/prop.

Aquadepot
08/04/2007, 10:12 AM
gosaints,

Please PM Roger "rvitko" your details and the issues regards repair.

Best Regards
Graeme