PDA

View Full Version : Vortech stalling!

rob020880
08/12/2007, 12:27 PM
Hello, I have a vortech pump and I have been running it for about a week. The pump seems to run fine but stalls out it seems every night. It runs good but then just goes out. The pump also seems to be running hot, but I don't know if this is normal. Is there anything I can do to stop this?
IceCap Service
08/12/2007, 12:54 PM
If it is stalling and running hot check the pin spacer for bent pins. If any are bent the motor magnet will rub against the spacer and cause stalling, possible noise, and can heat the motor more than normal.
rob020880
08/12/2007, 07:54 PM
The pins are fine. What else might be the problem?
IceCap Service
08/13/2007, 07:08 AM
Send the pump to Icecap 9B South Gold Drive Hamilton NJ 08691. We will inspect it and take care of any problems.
rob020880
08/13/2007, 10:47 AM
Should I send it to anyones attention? How long will it take to get it back?
IceCap Service
08/13/2007, 10:53 AM
Send to Service - work here will be 1-2 days max.
rob020880
08/13/2007, 12:00 PM
I sent it off to you guys. So keep an eye out. Thanks for the help.
mhurley
08/16/2007, 09:28 AM
[moved]