PDA

View Full Version : 7095 Question Australia


glenntur
09/15/2007, 12:01 AM
Hi
I have recently purchased a demo 7095 & just got a single 6055
The controller does not seem to be doing anything to the pump
regardless of settings Not pulsing the pump & the food timer does not turn off the pump Does only having one pump connected affect the control? After reading some of these posts i swapped cords & channels No difference
Any advice apreciated
Thanks Glenn :confused:

radone
09/15/2007, 08:49 AM
Glen
I believe there should be some kinda flow regardless, depending on the settings certain 7095 funtions don't seem to work. Usually with the 7095 it's nice to have the two pumps to see the beauty of the 7095 in action.

If it just doesn't work I would suspect another problem and I'm not capable to answer that for you.

Good Luck and will be curious to see what you find out Roger is at MACNA so maybe aquadepot can chime in on this one

glenntur
09/16/2007, 08:12 PM
Thanks for the reply mate
Hopefully one of the other guys might know more about the way the 7095 works
Cheers Glenn

rvitko
09/17/2007, 09:12 AM
Is the 6055 transformer on full power? On its 12V setting the difference may be too small to notice.

glenntur
09/17/2007, 03:01 PM
Yes Roger
The tranny is set on 24v
I have tried it with four different cables & all settings
Also swapped the ports on the bottom
All the lights change on the controller like its working but it does nothing to the pump
Thanks Glenn

rvitko
09/17/2007, 03:08 PM
There is a problem with the pump. You need a new motor 6055.10, please contact the distributor. I saw a pump like this as well in the states and the electronics were faulty and not recieving any signal.

glenntur
09/17/2007, 03:13 PM
Thanks for your advice Roger
Cheers Glenn