MSU Fan
09/27/2007, 08:02 AM
I just bought a used RO/DI unit produced by Kent (Maxxima 50gpd). I am testing the water outputing after the DI section, and my TDS meter is reading 6ppm. That has been pretty consistent so far with production. With that in mind, what should I do to get the water down to 0TDS?
Also, should the waste water output be less or more TDS than my tap? I thought that this had already gone through the RO unit and should be less, but my meter always shows it to be more.
Also, should the waste water output be less or more TDS than my tap? I thought that this had already gone through the RO unit and should be less, but my meter always shows it to be more.