rkl303
10/10/2007, 07:29 PM
I "recently" bought a Red Sea 50mg/hr ozonizer/controller from a friend but never see it being used. My ozonizer reads at 460mV.
Is this number readily achievable using just O2 and not O3? Or do you think its time for a new probe or possibly calibration?
My setup is a little unique in that all water that wants to go to the sump must pass through my G3 Skimmer as the skimmer is gravity feed. If I were to guess the flow rate through the skimmer I would guess my return line puts about 200~300gph.
Thanks,
Richard
Is this number readily achievable using just O2 and not O3? Or do you think its time for a new probe or possibly calibration?
My setup is a little unique in that all water that wants to go to the sump must pass through my G3 Skimmer as the skimmer is gravity feed. If I were to guess the flow rate through the skimmer I would guess my return line puts about 200~300gph.
Thanks,
Richard