Broken bracket for nanostream 6055

[guilford]

Roger,
I have two 6055 nanostreams. Both of them have problems with the bracket that mounts the pump to the magnet. On one of them the tabs on the bracket have broken off completely and it can't be attached to the magnet. For the second one, the tabs fit very loosely into the magnet and I don't know how much longer it's going to be able to hold. Is there a replacement part I can get for the two brackets?
Thanks,
Brad

[shawnz28]

Just shoot Roger (rvitko) a Pm with your name, address and what you need. These have since been redesigned and the new ones do not have this problem.

Shawn

[slider162]

I have a 6045 with the same problem. It is only a couple of months old and is supposed to be the new design. I'll shoot him an email anyway.

[shawnz28]

The brackets were just released a few weeks back. The pump might be the updated version fixing the shaft problems but the bracket most likely was not.

[slider162]

Ah, gotcha. Thanks for the info!