View Full Version : stand
mech0522
11/29/2007, 12:05 PM
i built a stand to pun my 90 gallon tank in the wall and i used 3/4 plywood top and its bowwed slightly that both ends of the tank has a gap what would u do fill it or ?????
thanks
daveverdo
11/29/2007, 12:12 PM
Could you post a picture or diagram of what exactly the problem is? How wide a gap? How long is the gap? Other info is helpful.
Without seeing the problem I would suggest removing the plywood top and adjusting whatever is causing the plywood to bow either by removing material from the high spots with a plane of sander or adding material to the low spots by building up with glued on shims. After that, replace the plywood.
Dave
mech0522
11/29/2007, 12:16 PM
ide say bout 1/16 on the edges and the center is tight
mech0522
11/29/2007, 07:23 PM
1
cpl40475
11/29/2007, 10:20 PM
did you sand the plywood for rough areas? if so you may have to shim the stands legs a liltte bit
vBulletin® v3.8.4, Copyright ©2000-2024, Jelsoft Enterprises Ltd.