View Full Version : How to unsnap the WWDbox top & base?
Just got my upgrade yesterday. I don't want to break the plastic case so could you please give me some pointers as to what to use and how to pry it open. Thanks.
11/30/2007, 11:16 AM
Use a rectangular razor blade and pop the two halves apart. Easier to start on the left side then move to the right side
11/30/2007, 03:06 PM
mdrumm's got it right. It's very simple using this technique.
Thanks both of you but since I don't know how the two halves snap together, I don't know how or where to put pressure to unsnap them. It looks like the tab should be pushed in toward the body, then pushed down, but it won't budge.
I don't want to break the plastic. It would be nice to have a drawing, Tim.
I left my phone number on Ecotech's support voice mail before I left the house but nobody called me back. Lacking a drawing, voice contact would be helpful. Thanks
11/30/2007, 04:46 PM
CJ, if you want shoot me a pm and I can help you. I think Ecotech is off for the weekend.
11/30/2007, 04:52 PM
We close on Fridays at 4:00PM. Just look at where the 2 halves meet. What I use is a thin blade screw driver. Just a slight squeeze and there will be a slight gap. Slowly work the screw driver tip around to each end and gently twist the blade slightly at each corner. Each corner will unsnap. Do this at all 4 corners. When I first tried it I was a little worried myself but have never fouled one up yet.
Thanks for the assist mdrumm.
Got it. Thanks a million. You too, mdrumm.
It is a little scary, glad I'm not the only one, :)
vBulletin® v3.8.4, Copyright ©2000-2013, Jelsoft Enterprises Ltd.