Tunze 6055

[MSHUR]

Roger told me that 6055 works on 8v. Do i have to change settings to 8v to controll this pump?

mike

[Fishie Nut]

Mike:
I have my Tunze 6100 set a 3-8 volts
I think there was a mention of this a loooong time ago in a thread.

[MSHUR]

George,
Thank you , i will try as soon as i got my pump back from Roger.
I looked throw they all threads but i couldnt find a answear..

m

[Fishie Nut]

I think it was in the Proline threads.
I don't think it's super important, but my are working fine a 3-8

[MSHUR]

I was trying to set up a wave but my pump was going on /off. i send it to roger and he tested on Tunze controller and said everything is perfect.

[Fishie Nut]

I have mine set as follows:
Pump 1: Permanent, Right angled waves, short and .9 seconds duration with no random reduction.
Pump 2: SAME, but Permanent opposite.
Pump 1 is set at 100 and 30 percent
Pump 2 is set a 99 and 31 percent
I also have them set to diminish at night 60 percent from 11:00 to 10:00.
I get a GREAT wave. I have one Tunze near the top of the tank and one in the middle on the opposite wall. The tangs love the current.

[MSHUR]

I only have one 6055. I specificaly got this pump to get a small wave:)
I will try this setting when i get it..
thankx..:)

[GeD]

I have the same problem. I have 1 tunze 6055 but it turns on/off at any configuration :(

[Matthias Gross]

Are we talking about waves or ebb/tide?
Mike, what are your settings exactly? Screenshot?

[MSHUR]

I got mine working. here is how i set it up for a small wave

Mode----permanent
Wave---right angle waves short
duration--0.8

this works for my tank,but every tank is different.Need to play with Duration to get a wave

m

[erikages]

Tunze pumps WILL turn on and off if you set the Profilux wave or pump power minimum below 30%.

This was a discovery for some (including me) and well chatted about a few months ago on this forum.

If you set 3-8v plus no less than 30% on your power output your pumps won't on-and-off ever again.

:)