Look at my programming.... ANd HELP!

[mr pink floyd]

My timer names are exactly as follows:
MH1*-A01
ACT*-A02
KR4&-A03
KR1&-A04
HET^-A05
SKM[]-A07
Fan^-A08

My programming is:
If Time > 07:30
Then ACT* ON

If Time > 12:35
Then ACT* OFF

If Time > 21:25
Then ACT* ON

If Time > 23:00
Then ACT* OFF

If Time > 12:29
Then MH1* ON

If Time > 20:30
Then MH1* OFF

If Temp > 83.5
Then MH1* Off


If Temp > 81.0
Then FAN^ ON

If Temp < 80.5
Then FAN^ OFF

If Feed cycle
Then KR1& OFF

If Feed cycle
Then KR4& OFF

If Temp < 79.0
Then HET^ ON

If Temp > 80.0
Then HET^ OFF
(KR1= koralia 1, KR4=Koralia 4, ACT=actinic, MH1=Metal Halide, SKM=skimmer, FAN=fans, HET= heater)




If Time > 00:00
Then KR1& ON

If Time > 00:00
Then Kr4& ON

If Time > 08:30
Then SKM[] ON

If Time > 20:30
Then Skm OFF

(* = symbol for lights, &= pumps. [] = square thing, ^= symbol for chillers/heaters)



I have no name, or anything on 6, because it WAS my fuge feed pump, which last night keep shutting off when it wanted to. I have all filtration and heat in my fuge, I couldn't risk it shutting off and freezing my tank.

thanks

[clp]

It would probably be best to call 408-578-3022 when you are in front of the controller, and I'll help you out.

Curt

[mr pink floyd]

another issue, my aquacontroller turns things on after they should, shuts them off after a few seconds, waits a minute, then puts it back on for a while.

when it does this, it shows the plug as being on, even when its off, or when it turns things on for a long time when they shouldnt, it shows theyre off...

[CMcNeil]

did you erase the stock programming before starting to name the outlets?i had the same problem you are having,the stock program conflicts with your program and things turn on and off when they shouldnt.

[mr pink floyd]

just talked to Curt on the phone, he told me the firmware was the first released, and that is the main problem most likely. Im putting in an order for a $9.99 cable, and hopefully that will solve everything.

Great service, thank you very much.

[mr pink floyd]

yup, i hit that init memory button, erased everything, then put mine in. then i hit init memory again to erase all mine, and redo mine again, less problems, bu still, problems.

[mr pink floyd]

one more question...

with the cable i ordered, will it allow me to use aquanotes? or just upload firmware?