Help with new stand

[reefknight]

Ok so here I am getting ready to upgrade to my new 90gal tank/ stand and canopy. I have been piecing it all together for the last couple of months. I measure the interior of the stand to make sure the new sump will fit, no problem. But wait, how do I get it in? The stand is the Perfecto Prestige stand that has a seriously wide front with two doors, not double doors! The rear has a center brace (attached with a pocket screwat the bottom along with staples and being glued it appears, the top just staples and glue again.) This also has a complete top and bottom on the stand. No matter how I twist it, rotate it or shove it, it won't go in. Any suggestions out there in DIY land? My first thought is the power saw and I don't care for that idea too much, so someone please stop me.

Please help the unstable man with the circular saw!