rjdudek
01/15/2008, 02:26 PM
I am moving the control head to a new location and the temp probe is just about 4' too short for where I would like to have it.
I am sure this is posted somewhere but I could not find it. Can I just make a 4 foot jumper cable for the temp probe or is it balanced to the resistivity of the OEM cable.
I can find a female/female connector and make a new cable?
Thanks
I am sure this is posted somewhere but I could not find it. Can I just make a 4 foot jumper cable for the temp probe or is it balanced to the resistivity of the OEM cable.
I can find a female/female connector and make a new cable?
Thanks