Chago09
02/27/2008, 06:43 PM
I just bought one of these stands and hood combos for my 90 gallon
http://www.marineland.com/sites/Marineland/products/productdetail.aspx?id=2054&cid=2049&mid=3228
Well I bought a 30" 29 gallon tank for my sump and guess what?? it won't fit!!!:mad2:
I measured and I forgot to add in some corners when you turn the tank. Well the front of this stand has a large piece down the middle which I though would be ok since the back is a much bigger opening. the back has a 3" strip down the middle. From What I see there is only one screw holding this into place and some wood glue. Is there any likely hood that I can remove this piece without breaking everything, then simply add the sump in and then put the piece back??? its a piece of 3/4" painted plywood.
http://www.marineland.com/sites/Marineland/products/productdetail.aspx?id=2054&cid=2049&mid=3228
Well I bought a 30" 29 gallon tank for my sump and guess what?? it won't fit!!!:mad2:
I measured and I forgot to add in some corners when you turn the tank. Well the front of this stand has a large piece down the middle which I though would be ok since the back is a much bigger opening. the back has a 3" strip down the middle. From What I see there is only one screw holding this into place and some wood glue. Is there any likely hood that I can remove this piece without breaking everything, then simply add the sump in and then put the piece back??? its a piece of 3/4" painted plywood.