Firmware update.

[Creetin]

So i assume i can go from 3.06 to 4.03 without a prob. I thought i read that the jump must be made from 3.08.
Looking to update here shortly so i await to make the jump.
Thanks

[Creetin]

also i updated to 4.0 to my computer and now i cannot connect to the profilux. It says cannot find (W)lan connection.

[AQD_ottawa]

Hiya

When you go from a previous version to 4.0 you must save your settings first.

Have a read through the V4.0 thread there are some resources in there that point to this.

[Creetin]

Thanks i found this. Will do on the read thru.

- update the firmware to 4.00 with ProfiLuxControl 3.0.8.1
- now use ProfiLuxControl 4.0.0.0 to load the settings and sensor data back
- check the settings and readings to be sure everything is working well

[Creetin]

OK i have it installed and i am getting 3.0 readings on both of my ph probes. I reinstalled probe settings and still get 3.00 readings, and will re calibrate probes, But i dont think recalibrating them will have anything to do with this error.
What do you guys think??
TIA

[AQD_ottawa]

recalibrate and see, then let us know

[Matthias Gross]

did you save the sensor data before update and load them back after update? If not: do so.
If you forgot to save the sensor data: recalibrate all probes

[Creetin]

Ok i recalibrated, and all seems fine now. That was strange, maybe the sensor data conflicted?
Dunno, But all probes are recalibrated, and seem to be inline.

[Creetin]

<a href=showthread.php?s=&postid=12063464#post12063464 target=_blank>Originally posted</a> by Matthias Gross
did you save the sensor data before update and load them back after update? If not: do so.
If you forgot to save the sensor data: recalibrate all probes

Yes and did that,,, for some reason they wanted to say 3.00 :)
They are ok now.
Thanks.