deltec e-z clean question

[joelk835]

I recently made a large bucket batch of ez-clean water to clean my pumps. Can I clean my probes for my aquacontroller in this solution or will it damage them? Also does a batch go bad or is there anything can happen if I keep my bucket of water and ez clean to clean further equipment. This stuff isn't cheap so I thought if I could reuse my batch that would make sense.

[UberReef]

Here is my experience: If the probe tip are cleaned every two-three weeks with a toothbrush and regular RO/DI water, you would not need to use any abrasive or low pH solution in order to clean your probes. If you must I would option just to use a light vinegar solution in order to clean your probes. Using this type of product on your probes, will work yes. However running 93 octane in a standard flat pan motor is not always the best idea as well, even though you will get amazing results in the beginning. Just use the good old tooth brush and water method, as this proves to be very effective in maintaining your delicate probe tips.