How do you disassemble the wet end?

[nanoguy]

I need to take my wet end apart for a cleaning/change out the magnet and I'm not sure how to do it. Is there any documentation with instructions on how to disassemble the wet end? Thanks.

[EcoTech Service]

First remove the nozzle. Press against the frame and rotate slightly CCW and it will slip right off. Then remove the nut. Should be able to easily do it without any tools. If a bit snug, press against the magnet then try to loosen. After the nut is removed all components easily slip right off. Just remember the proper order. You can also refer to www.ecotechmarine.com and look at the parts break down.

[mrcrab]

Make sure when you put it back together to only tighten the nut by hand.

Don't use a screw driver as you'll scratch the coating on the magnet if not careful.

[nanoguy]

Thanks fore the info......I will give it a try tonight.