fishfanatic06
05/21/2008, 07:40 AM
Recently my Korralin Calcium reactor is acting very strange. I will set the bubble rate to 1 bubble every 5 seconds and over the course of a few hours the bubble rate drops off to the point where no bubbles are produced at all. I have the regulator set at 20 psi and I have water going to the reactor via a pump that is t'eed off. The drip count always stays the same.
BTW, I don't know if it helps but I took the reactor apart the other day to clean it out and I took apart the brass check valve thing in between the co2 tank and the reactor and cleaned that out too. Maybe i put the check valve on wrong?
Please Help! Thanks!
BTW, I don't know if it helps but I took the reactor apart the other day to clean it out and I took apart the brass check valve thing in between the co2 tank and the reactor and cleaned that out too. Maybe i put the check valve on wrong?
Please Help! Thanks!