View Full Version : drilling skimmer body
how should i drill my ASM mini-g so i can add a feed pump for my recirc mod? I think i can use a dremel to cut the hole but i want to be sure.
thanks!
klm2500hd
09/25/2008, 08:24 PM
dremel works good. I've found lower speeds work well on acrylic.
Freed
09/25/2008, 08:28 PM
Hole saw and a drill. Perfectly round hole with smooth edges.
scaryperson27
09/25/2008, 11:22 PM
^ ditto. You will need some sort of guide with a dremel. that or a realllly good eye...
Everyones Hero
09/26/2008, 11:29 AM
The old Dremel I had had a guide for circles. It was a bar with the middle drilled out. One end became the center of the circle & you attached the Dremel to the bar. Say you want a 2" diameter circle you put the Dremel 1" out from the center point.
Hope that makes sense.
ok thanks guys, I'll go try a dremel and some drill bits.
vBulletin® v3.8.4, Copyright ©2000-2024, Jelsoft Enterprises Ltd.