PDA

View Full Version : leaking valve


tedmc2
10/07/2008, 05:22 PM
I had to replace the IN valve on my Typhoon III unit but it is leaking. I tried putting silicone sealant around it but I think the pressure is too high.

Do you have any suggestions?

Thanks
Ted

ybenormal
10/07/2008, 08:13 PM
You should not need to use silicone on any of the fittings. First, make sure that the hose is cut straight and even. Better yet, recut it just to make sure. Then push the hose in firmly to make sure it is fully seated in the fitting. Test again to see if it still leaks. If so, send and email to AWI (faster response than forum postings).

tedmc2
10/08/2008, 06:21 AM
Thanks