Nano Cone problem

[thysrof]

Victor,

I have a Nano Cone Skimmer. I'm using the mesh wheel. I've just noticed larger bubbles in the reaction chamber and the performance is next to none. Another poster reccomended making sure the mesh wheel hasn't come loose. I checked and it's secured to the platice disk. Any suggestions?

Thanks Bob

[GSMguy]

the burping is usually from loose or compromised mesh, if it is tight to the disk it might need trimming, or it could need a full recharge ( IE new mesh), thats why i love the pinwheel, all my PW skimmers have been so reliable.

can you take a picture of your meshwheel? it will help in diagnosing your problem, and if the guy you bought the skimmer from wont send you the pinwheel I'm sure Victor has one laying around from one of the 1250s he upgraded for customers on their small.

[victor90]

Did you use pliers to tighten the mesh? It will seem tight by hand but pliers should be used. Yes pictures of the bubbles will be helpful. Is it newly setup?

[GSMguy]

i dont want pictures of the bubbles i want pics of the meshjob itself.

[thysrof]

Well I haven't posted pictures to RC. I know how to email pictures. The user manual didn't come with the unit so I'm flying a little. how do I tighten the mesh wheel with plyers?

Victor can I email you a picture of the mesh wheel?

The skimmer has been working fine for 2 months,so this is a recent problem.

Thanks Bob

[thysrof]

Victor,

I emailed mesh pictures to your customer care email.

Thanks Bob