PDA

View Full Version : did i fry my........


Pescado Amigo
12/07/2008, 09:08 AM
membrane???

This time of year I run a mix of hot/cold water to make water. While i was out my wonderful wife "helped' me out and shut off the water. The problem is she didn't know the hot water was on and the hot water ran about 24 hours through the membrane. Did I fry it?

pedro

Buckeye Hydro
12/07/2008, 10:52 AM
Filmtec warranties are voided if the temperature exceeded 113°F. I suspect your hot water is somewhere between 130 and 140°F. But you may have been lucky - break out your tds meter and check the rejection rate. Also check out the amut of water the membrane produces and see if it is near the factory spec.

Russ

Pescado Amigo
12/07/2008, 11:35 AM
thanks I will do just that....

sohal1025
12/08/2008, 08:46 AM
The same thing just happened to me....You are not alone!