reeftank21
01/13/2009, 10:32 PM
I have replaced a 6101 with a 6105. I had 2 6101's opposing each other on an 8' tank and now have a 6105 on one end and 2 6101's on other end.
The 6105 really seems to push much more water than the 6101. I have actually put the 15v jumper in instead of the 24v. I can't imagine tanks that have several pumps or tanks with 6205's.
Is there any problem with "Pmp Int 00/100" as opposed to what I had before which was "Pmp Int 30/100"? The wavebox pumps go from 0 to 100 so why not the 6105's. I did not do this with the 6101's because it appeared the mounting clips could not take the stress of 0 to 100 percent. I belive this to be much better for the corals, especially the ones close to the pump. Not so much of a constant flow on the corals. The 6105 mounts don't even budge.
Thanks for any advice.
The 6105 really seems to push much more water than the 6101. I have actually put the 15v jumper in instead of the 24v. I can't imagine tanks that have several pumps or tanks with 6205's.
Is there any problem with "Pmp Int 00/100" as opposed to what I had before which was "Pmp Int 30/100"? The wavebox pumps go from 0 to 100 so why not the 6105's. I did not do this with the 6101's because it appeared the mounting clips could not take the stress of 0 to 100 percent. I belive this to be much better for the corals, especially the ones close to the pump. Not so much of a constant flow on the corals. The 6105 mounts don't even budge.
Thanks for any advice.