View Full Version : Trouble with octopus
danfrith
01/17/2009, 10:06 PM
Well, I bought the octopus NW 150 about a month ago, heres the model I bought http://www.aquabuys.com/miva/merchant.mvc?Screen=PROD&Product_Code=vue-nw-150&Category_Code=s1&Product_Count=11
At first it worked ok, but now only seems to produce a little bit of skimmate after I clean the collection cup, and then after that it just builds up along the inside of the tube. Its in the sump of a 65gal. SPS tank with a moderate/high fish load. Any help to get this skimmer producing skimmate would be greatly appeciated. Thanks.
Kabuto
01/17/2009, 10:33 PM
What is the water height in the sump to the skimmer? Have you checked the needle wheel?
danfrith
01/17/2009, 10:42 PM
I dont know at the moment . Im not at home. But if I had to guess I'd say 9-10 inches.
danfrith
01/17/2009, 11:23 PM
What water height should it be in?
bmxdad
01/18/2009, 08:15 AM
mines sits in about 8.5 inches of water, the water level in the top area under the collection cup should be just below the little u cut out. use stand pipe to adjust water height. mine took a little playing with to get it right. produces lot of dark green skimmate.
chuck
danfrith
01/18/2009, 02:01 PM
Well, I measured and its in 9 1/2 in. of water. How do you do adjustments on this skimmer? Thanks.
E.intheC
01/18/2009, 06:35 PM
you can try adding a stand made of pvc or even egg crate if you do it sturdy enough. 2 inches or so should do it
phish guy
01/18/2009, 06:41 PM
not to hyjack your thread, iv had mine installed (octo nw-110) since june. broke in, worked fine for months. i took it out to clean it, put it back in and now its producing really light skimmate. is it just breaking in again?
any thoughts?
vBulletin® v3.8.4, Copyright ©2000-2024, Jelsoft Enterprises Ltd.