pdfrogman
01/28/2009, 04:29 PM
I bought a used AC3
the ORP probe was way off from my Milwaukee so I attempted to recalibrate it using just the pinpoint ph correction fluid now it stays at 254 and doesn't move is there a way to reset the controller back to factory specs?
I thought the probe was bad still didn't move after I replaced the probe
I also need to reprogram the controller so it might be easier to start from scratch
Thanks!
Frank
the ORP probe was way off from my Milwaukee so I attempted to recalibrate it using just the pinpoint ph correction fluid now it stays at 254 and doesn't move is there a way to reset the controller back to factory specs?
I thought the probe was bad still didn't move after I replaced the probe
I also need to reprogram the controller so it might be easier to start from scratch
Thanks!
Frank