luckydog104
02/22/2009, 10:40 PM
A couple friends of mine have been trying to drill some tanks this week but have had some bad luck. They tried a 55 but found out afterwards that it was tempered . Today they tried a 10 gallon of mine just for a practice attempt and well I don't have the ten gallon anymore. They are planning to drill a 150 and have checked with the manufacture , the 150 is not supposed to be tempered on the sides just the bottom. They drilled the side of the ten it was apparently tempered as well. Is there a way to tell for sure before they do the 150? Could someone offer up some tips on drilling glass ? One of them may have posted about this but I have not seen it anywhere , just trying to help. Thanks