Mako
03/26/2009, 09:29 PM
Here recently my alarm on my ACPro refuses to stay in Auto mode. If I place it in Auto via Aquanotes it just reverts to Manual/off. Can do this over and over and it just simply refuses to go into Auto.
If you go to the controller interface the display shows the ALM in manual. Go into setup/manual control/ALM/ it shows it is set to Auto. If I turn it off and then back on then exit out to display it shows the ALM is no longer in manual and everything looks good. Go back to Aquanotes and low and behold ALM is in Auto.
Anybody seen this before? Possible bug in the firmware??
If you go to the controller interface the display shows the ALM in manual. Go into setup/manual control/ALM/ it shows it is set to Auto. If I turn it off and then back on then exit out to display it shows the ALM is no longer in manual and everything looks good. Go back to Aquanotes and low and behold ALM is in Auto.
Anybody seen this before? Possible bug in the firmware??