bioneck47
03/31/2009, 11:37 AM
I have a warner marine skimmer that has way too much turbulance at the neck, no matter how much air I allow in, and would like to extend/lengthen the neck by about 8". I'm sure that this would definetly improve the overall performance of the skimmer. It is a recirculating skimmer with two eheim 1262's and doesn't really pull any skimate.
I was thinking of making a cut at the neck and just adding an 8" peice of acrylic with the same diameter. Would this be too difficult of a task? How do I make such a precise cut to allow the pieces of acrylic to lay flush?
I was thinking of making a cut at the neck and just adding an 8" peice of acrylic with the same diameter. Would this be too difficult of a task? How do I make such a precise cut to allow the pieces of acrylic to lay flush?