Kengar
05/30/2009, 02:30 PM
Should the DHCP setting under NetSetup (ACIII) be set to on or off?
(For what it's worth, I'm trying to trouble-shoot. For some reason I can't seem to communicate with the ACIII through the wireless router, either trying to connect directly to it (192.168.1.50) or via my DnyDNS-based address. I use a Netgear ethernet extender, one plugged into the wall by the tank and one plugged into the wall by the router, and the three led's are lit on each module indicating there is communication between the router and the ACIII across the house's electrical wires. Additionally, the amber and green led's on either side of the ethernet port on the ACIII are each lit (green blinking, amber steady). But for some reason, I can't get communication. Hmmmmmmm. It was working previously today, since power went out, tank temp dropped, and my alarm started sending emails when power was brought back on, but I just can't get the control interface. Any thoughts on this?)
(For what it's worth, I'm trying to trouble-shoot. For some reason I can't seem to communicate with the ACIII through the wireless router, either trying to connect directly to it (192.168.1.50) or via my DnyDNS-based address. I use a Netgear ethernet extender, one plugged into the wall by the tank and one plugged into the wall by the router, and the three led's are lit on each module indicating there is communication between the router and the ACIII across the house's electrical wires. Additionally, the amber and green led's on either side of the ethernet port on the ACIII are each lit (green blinking, amber steady). But for some reason, I can't get communication. Hmmmmmmm. It was working previously today, since power went out, tank temp dropped, and my alarm started sending emails when power was brought back on, but I just can't get the control interface. Any thoughts on this?)