reeflow 200 with pro set up

[royvoss]

i finally found some time to install the pro set up on my skimmer, is there any instructions for this? not sure were the water level should be. i know it need to break in for a couple of weeks.

thanks roy

[JRaquatics]

There is instructions to swap out the impellers on our site but as far as water running level and such is dependent on the bioload and the feed. I ran mine at about 300gph and ran the water level at about 1/2" under the collar where the cup attaches.

[royvoss]

thanks for the reply, thats were i had it befor the mod. i just left it there. all i can do is wait for it to break in. i have the wedge pip open all the way. my tank is abpout 160 gallons total. but i feed twice a day. not heavy. but i have 10 fish, four are tangs. not alot of corals yet.

[JRaquatics]

If I remember correctly I actually lowered the water level in the skimmer once I added the pro upgrades. All I know that is where I ended up. I tested so many wheels with the skimmer that my favorite setting on the skimmer were lost. Just remember that it took close to two and a half weeks for the skimmer to re-break in with the addition of the pro wheel and cup.

[royvoss]

thanks for the info, so far it has been over 24 hrs. it seem to be doing great. should be awesome in a few weeks. i am getting skimmate. and a nice foam head has formed. again the wedge pipe is wide open. should have installed this months ago.

roy