Tunze Osmolator

[AL915]

I have had my Tunze Osmolator for about three weeks to a month. Today when I was going to fill up the storage tank, I noticed that it was full and the sump was way below the sensor. So I unplugged the Osmolator and it started to work again. Half way through, it stopped again. Any ideas would greatly be appreciated.

[rvitko]

I am 90% sure this is a controller problem, there is a current limited that kills the pump if it draws more power than it should. The only other causes can be corroded wiring or terminals or a bad pump. It is so new though that it is more likely the controller. I will send a PM.