Can't add a DC8 to APEX

[GlassReef]

Sorry if this has been covered, I did a search but found nothing.

Using the Display Module, if I go to Setup>Module Setup>Add Module, it lets me add a DC8 with a start address of A01 - and then SAVE it. Next time I look for it, it's gone. I've done a Restart, etc. All to no avail. I'm using the latest firmware.

Can someone tell me what I doing wrong?

Thanks

[kenargo]

Where are you looking for the DC8? Once you add it using the modules screen you should get 8 outlets A01-A08 in the Outlet Setup.

I suspect you may have expected to see the DC8 in the modules list but it really isn't a 'module' (only AquaBus devices apply there) but that was the better location to support adding legacy devices (e.g., DC8, DC4HD, LunarSim, etc).

[GlassReef]

That was it. Thanks Ken! :D :o