mp40w problem

[wongkwp]

I've been having this issue after disassembling the wet side for cleaning and re-assembled it back. The pump will run for a while and then would stalled. I noticed that the propeller is not spinning and instead, it is the screw that was spinning until the nut became loose causing the problem Any recommendation to fix this?

[EcoTech Marine]

Please give us a call at the number below and we can walk you through some things then get you any parts that you may need. If no one picks up, just leave a message with a return number and we'll call back.

[wongkwp]

Thanks. I've contacted Technical Support and talked to Steve.

[wongkwp]

I've received the replacement drive shaft and propeller but it does not resolve the problem. This is what happened when I turn on the pump, somehow, the wetside just pop and came loose.

http://i81.servimg.com/u/f81/12/21/19/76/mp40w_10.jpg

[EcoTech Marine]

Peter. Call Steve back at the number below, he'll make sure you got the parts assembled properly or replace the wet side.