Where would you place this candy cane coral? FTS included

[Korrine]

It's a 29g tank w/a 250w MH over the center.

I have a 3 headed candy cane coral. I'd like to eventually add a frogspawn or hammer and have some LPS on the sand bed. I do have a few tiny zoa colonies on the rocks now.

Where would you put the candy cane?

http://i248.photobucket.com/albums/gg200/kj23502/sw%20tank/PB140269.jpg

[dclaassen]

Just personal opinion but as you look at that pic I would put the candy cane on the left side where your lower rock meets the rock that goes up higher. I think the frogspawn or hammer would look good in the middle a little to the right tucked in with the rock that is in the shape of two fingers.

[Korrine]

good thinking.

This is my first time placing something that isn't a zoa :)

[cody6766]

Off to one of the sides. My candy doesn't like bright light or heavy flow, so keep that in mind. It puffs out a lot more instead of hugging the skeleton when in low flow and light

[Korrine]

oh wow. Thanks for the tip :bounce1:

[Korrine]

I glued it in place using Aquastick. It was the first time using that stuff...REEKS....STINKY

http://i248.photobucket.com/albums/gg200/kj23502/sw%20tank/PB170384.jpg

And a shot of one of my peppermint shrimp that I just released.

[Korrine]

Oh and the skimmer FREAKED out when I added the epoxy

http://i248.photobucket.com/albums/gg200/kj23502/sw%20tank/PB170387.jpg