PDA

View Full Version : geosreef cr618 calcium reactor setup?


arinova8
12/14/2009, 10:41 PM
hi i recenlty inherited a geosreef cr618 with a milwaukee ph controller need help setting it up anyone have this setup that can guide me thru it?

like where should i set the ph controller at ?

i have very little coral now about 3 stonies and softies, what should the effluent be set at a drip or slow flow back into the sump?

thanks guys

arinova8
12/14/2009, 11:09 PM
? anyone

RokleM
12/15/2009, 08:00 AM
If your tank is pretty much empty, you might not even need it yet at this point. I assume you're watching your parameters? How much daily or weekly drop in calc/alk do you have?

Manuals from GEO's site:
http://geosreef.com/caReactorInstructions.pdf
http://geosreef.com/forms/pump_installation_instructions.pdf

arinova8
12/15/2009, 12:55 PM
i just started monitoring it yesterday but question i'm using caribsea coarse calcium media in the reactor what setting would be best to set the milwaukee controller to???

troynel
12/15/2009, 02:44 PM
it all depends on your calc and alk needs. I would say you don't have to much demand at this point and would set the ph level at 6.9

arinova8
12/15/2009, 03:03 PM
hey troy so i should set the small dial in front of the milwaukee controller to 6.9 do you have a geo reactor ?