Interval mode with 7094 controller.

[jthomps123]

Im trying to setup up two 6100's on a 7094 controller in interval mode - ie one on for a minute or two, then it cuts off and the other pump turns on. I am having problems having it switch to the second channel. I have the pumps plugged into sockets 8 and 11. Have the interval time set to 1-7 minutes. Have the mode switch in the highest position (low/high tide). The interval light is on byt it never switches.

I have it set up like the manual suggests but channel two never goes off.

Any help would be great. Thanks.
Jason

[rvitko]

Is the interval light on on the controller?

[jthomps123]

Yes the interval light is on.

[rvitko]

It sounds like the relay is bad in the controller, we no longer have parts for the 7094, it hasn't been made since 2004. I might try unplugging the pumps from power and reconnecting everything and giving it another shot. The 7094 used a standard electromagnetic relay and these could stick after thousands of cycles.

[jthomps123]

It sounds like the relay is bad in the controller, we no longer have parts for the 7094, it hasn't been made since 2004. I might try unplugging the pumps from power and reconnecting everything and giving it another shot. The 7094 used a standard electromagnetic relay and these could stick after thousands of cycles.Is it a standard relay? Something that can be replaced with some soldering skills?

[rvitko]

Yes, you should be able to find one from a specialty electronics supplier on line, I would caution though that usually when the relay sticks a couple diodes and possibly a capacitor have been damaged as a result, usually these repairs are like a dog chasing it's tail and you fix one thing just to find another problem and often that problem damages the work you just did. If you are interested in a 7095 or 7096, I will give you a discounted upgrade.

[jthomps123]

Thanks for the info. PM sent.