FISHUNT-72
01/10/2010, 02:55 PM
Is it possible to cut the end off of this sump where the bulkhead goes through?I need this sump to be shorter and I have a submersible pump.I could cut it on the tablesaw and clean it up with a router.Then weld a new piece on the end.Also is there a way to remove the old bio-ball divider and weld in some new baffles.Or would it be better to ebay this and start over.
http://i764.photobucket.com/albums/xx285/fishunt-72/101_2459.jpg
http://i764.photobucket.com/albums/xx285/fishunt-72/101_2459.jpg