PDA

View Full Version : EB8 showing 0 amps


madmike
06/12/2010, 11:42 PM
I have a new apex that is running great, has 2 EB8s attached to it but only one will read amperage, the other just shows 0 even though there are pumps running on it. Any idea how to fix?

thanks

aquamanic
06/13/2010, 07:45 AM
If the software shows (OK) for the EB8 on the module status screen then you have to call Neptune (if not, then update the firmware to the EB8). There's some utilities they can run to tune the amp reporting on the EB8.

madmike
06/13/2010, 10:21 AM
ok, thanks, i'll give neptune a call.

Mike