WXM - MP40w ES Recognition Help!!

[1leftygolfer]

Just not having any luck with getting the Wireless Module and MP40W ES pumps to sync. I've performed the firmware updates - Rev 4.03 - 5B10 Build #2, and updated the module. Next, EcoSmart Update Manual firmware downloaded in the module, but had an error message 3 times (disconnected the bus to reload) before successfully getting to "Begin Pump Firmware Update". With Pumps off, holding the set and mode buttons, powered up one pump - get red, white, and blue color indication - suppose to be red/white...??? Module to Pump controller distance - 12".

I tried my other pump with same results. Appreciate any assistance with helping out a rookie.

[1leftygolfer]

Update - performed a firmware and web page update = 4.03_6A10
Still no luck.

[Wall_Tank]

With Pumps off, holding the set and mode buttons, powered up one pump - get red, white, and blue color indication - suppose to be red/white...??? Module to Pump controller distance - 12".


Read the rest of the procedure. The Mode and Set buttons, leading to a Red/White/Blue color is only the 1st step of 5

With pump powered
Reset Pump
1) Press Mode and Select for about 3 sec ---> Flashes Red/White/Blue
2) Press Mode for 3 Sec ----> Flashes Purple/Red
3) Press Set ----> Pump Resets
Assign to WXM
1) Press Mode and Select for 3 seconds --> Flashes Red/White/Blue
2) Press Set ---> BLinks Blue/Yellow

You should now see the pump on the Apex Module page.