T8T
07/12/2010, 09:54 AM
I am going to fabricate a pH probe holder from acrylic. What is the reccommneded depth that the probe be submerged in water?
Would it be better to fabricate something "in-line"? I've seen a few here have built these with ease. However I do not have a Ca Reactor. Is it neccessary to do it this way only if you have a Reactor?
I have a manifold built into my return that used to employ a couple of TLF reactors but are currently offline.
I just want to do it right the first time, any suggestion would help.
Thanks.
Would it be better to fabricate something "in-line"? I've seen a few here have built these with ease. However I do not have a Ca Reactor. Is it neccessary to do it this way only if you have a Reactor?
I have a manifold built into my return that used to employ a couple of TLF reactors but are currently offline.
I just want to do it right the first time, any suggestion would help.
Thanks.