Moroco
07/16/2010, 01:34 PM
My Typhoon III Extreme doesn't seem to be producing much water. The PSI gauge on it reads under 10. My input water is 40-50 PSI. The pressure seemed to start dropping a couple weeks ago.
I've replaced the ASOV, bypass valve, membrane and tried several things already like running it without filters. Without any filters (including membrane) the PSI gauge gets up to 18. Is it normal to go from 40-50 input to 18 without any cartridges?
After adding the first 2 pre-filters back (a 10 micron and 5 micron), the PSI reads 16, Then drops down to 0 when the 3rd pre-filter (1 micron) is in there (that's without the membrane in there).
Could the 1 micron be the problem? I replaced the old one about a month ago, so it's not very old.
I've replaced the ASOV, bypass valve, membrane and tried several things already like running it without filters. Without any filters (including membrane) the PSI gauge gets up to 18. Is it normal to go from 40-50 input to 18 without any cartridges?
After adding the first 2 pre-filters back (a 10 micron and 5 micron), the PSI reads 16, Then drops down to 0 when the 3rd pre-filter (1 micron) is in there (that's without the membrane in there).
Could the 1 micron be the problem? I replaced the old one about a month ago, so it's not very old.