PDA

View Full Version : WXM and Gen2 MP40W


tzzhc4
08/23/2010, 02:54 PM
I just got my WXM today and hooked it up. My 3 Ecosmart pumps sync'd right up with no issues. My 2 MP40W pumps on the other hand are not doing the same.

My MP40W's are original gen 2's from 2008 so I tried upgrading the firmware from the WXM per the instructions. I shut off every other pump and every other wireless device in my house (just to be safe) and attempted the upgrade. The MP40W will flash blue quickly for a couple seconds and then go back to flashing red/white, while this is going on the display on the Apex shows a continually increasing percentage until it reaches 100% and then says no pumps were upgraded. My Apex is running 4.03-6A10.

aquamanic
08/23/2010, 04:46 PM
Cycle the power to the WXM then try the update to the pump drivers again. See if that helps.

tzzhc4
08/23/2010, 04:46 PM
I spoke with Curt at Neptune and I wasn't waiting long enough for the firmware to download in the RF. Once I was just patient enough to wait the upgrades of my MP40W Gen2 went smoothly. Thank You Curt!