wampuscat
10/02/2010, 09:03 PM
I did have my ro/di unit connected as follows: pre filter, booster pump, sediment filter, two 0.5 micron carbon filters, pressure gauge, filmtec membrane and then through two di resin filters.
I WAS TOLD THIS WAS WRONG AND HAVE CHANGED IT TO THIS.....
Pre filter, sediment filter, two 0.5 carbon blocks, booster pump, pressure gauge, filmtec memrane and then to the two di resin filters.
Before my pressure gauge read about 92 psi, where I have it placed now it goes crazy at about 100 psi and makes a noise and flickers very fast.
Do I have it placed in the right place or was it right before?
Thanks,
Billy
I WAS TOLD THIS WAS WRONG AND HAVE CHANGED IT TO THIS.....
Pre filter, sediment filter, two 0.5 carbon blocks, booster pump, pressure gauge, filmtec memrane and then to the two di resin filters.
Before my pressure gauge read about 92 psi, where I have it placed now it goes crazy at about 100 psi and makes a noise and flickers very fast.
Do I have it placed in the right place or was it right before?
Thanks,
Billy