hamholla
11/05/2010, 11:25 PM
so i have been looking around for well explained pvc overflow directions for my 29 gallon dt and 10 gallon sump...
i have found a few but none of them are very consistent...
What would be the best way to go about this? i already have many of the materials i need i would just like some directions :fish1:
on a semi-related note... i have an aquaclear 50 powerhead rated at 270 gph... could i not connect a piece of clear tubing i have to the end of it and insert the end of the clear tube into a piece of pvc that then runs to the sump?... that seems like a pretty fail safe way to pump water to the sump without using a ton of pvc in my tank...
i have found a few but none of them are very consistent...
What would be the best way to go about this? i already have many of the materials i need i would just like some directions :fish1:
on a semi-related note... i have an aquaclear 50 powerhead rated at 270 gph... could i not connect a piece of clear tubing i have to the end of it and insert the end of the clear tube into a piece of pvc that then runs to the sump?... that seems like a pretty fail safe way to pump water to the sump without using a ton of pvc in my tank...