PDA

View Full Version : Mp40


birdman1979
01/08/2011, 04:17 PM
Hi,
I'm having a very difficult time programming my mp40's. I have one MP40 ES and on MP40W GEN 2. I tried setting them up in anti-sync mode but don't think they are compatable? NextI tried just getting them to run independently. I was able to reset my MP40 ES and it is running fine. The MP40 GEN 2 i reset by holding mode/set, holding mode, then holding set. The pump appears to reset but after about 5 seconds it begins flashing red. No matter how many times i reset I get the same flashing red after five seconds. I am UNBELIEVIBLY frustrated with these pumps.

belgian_waffleman
01/08/2011, 09:54 PM
It took me a while to make the mp40 2nd gen to be the slave of the mp40 es. They are compatible. You have to clear both first. Then use set the new one (es) as the master. Then use the old manual to configure the mp40w 2nd gen as the slave,anti sync.
good luck.

Waffleman

EcoTech Marine
01/11/2011, 08:57 AM
The flashing red is a common issue that's easily correct, just review our website FAQ section:

http://ecotechmarine.com/customer-service/

and more specifically here:

http://ecotechmarine.com/faq/troubleshooting/my-pumps-driver-is-blinking-red-what-should-i-do/

birdman1979
01/12/2011, 12:43 AM
Fixed! I love my vortechs again!